Assemble the 4 spade connectors into the supplied plastic connector housing. This connection has been supplied disassembled to assist with routing through the firewall or any tight locations.ĥ. Route the 4 loose male spade terminals of the long section of the loom. HINT – Low beam headlamp or fuse box may be an adequate source.Ĥ. NOTE – If shortening the red/yellow and/or blue/white wires, make sure not to remove the heat-shrinked inline diode that protects sensitive electronics from current leakage. Connect the blue/white wires to this circuit using a method of your choice. Locate an illumination circuit (a circuit that powers on when the headlights are engaged) using a multimeter. HINT – Cigarette lighter or fuse box may be an adequate source.ģ. The compressor will not power on if this step is not performed. Connect the red/yellow wire to this circuit using a method of your choice. This circuit must only be live when the vehicle ignition key is in either the ‘ACC’ position or in the ‘ON’ position. Locate an ignition/ACC power circuit, minimum 8 amps, using a multimeter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |